Venosafe® Plastic Tubes: Serum Gel - VF-106SAS

	Product Type	—	Serum Gel
	Catalogue Number	—	VF-106SAS
	Nominal Volume	ml	10
	Draw Volume	ml	6
	Additive	—	Gel + Clot activator
	Concentration of Additive	mg/ml	—
	Dimensions - Length	mm	100
	Dimensions - Diameter	mm	16
	Stopper Colour	—	Cherry red
	Cap Colour	—	Transparent cherry red
	Shelf Life	month	24
	Centrifugation Rate	G/min	1200/10 (± 100)
	Unit Box	pcs	100
	Shipping Carton	pcs	12x100
	Measures Unit Box	LxWxH	332x110x82

Instructions for Use:

• After blood collection, gently invert the tube several times to maximise the contact between blood and silica.
• Allow the blood to coagulate during 30 min.
• In emergency, one can reduce the clotting time, but there can be no guarantee for complete clotting.
  In case of uncompleted coagulation and due to the mechanical stimulation of the blood coagulation, fibrin formation may occur during centrifugation. This will be observed as a gelatinous mass in the serum.
• Centrifuge the tube at room temperature, during at least 10 min. with a relative centrifugal force of 1200 G (± 100 G).
  For optimal barrier formation a swing-out rotor is recommended.
  Although the tubes withstand 4000 G (with stopper) the use of higher centrifugation force is not recommended.
  Higher centrifugation force might reduce the centrifugation time but will increase the amount of cells on top of the gel.
  Lower centrifugation force might result in an incomplete gel barrier.
• After complete separation with the gel barrier in place storage requirements depend on the stability of the analytes and are equivalent to storage requirements for decanted serum samples.